1. Hold pointed end of the E/Z Twist tight with your left hand and turn hex end clockwise with right hand to the closed position.
2. Insert wire through slot in hex end and push wire through tool. Form loop and insert tag end of wire through opposite side hole in the pointed end of the E/Z Twist, leaving aprox. 3" of wire beyond tool.
3. Hold desired size of loop in left hand and form twists by rotating E/Z Twist six times clockwise with right hand.
4. Remove tag end of wire from E/Z Twist by pooling loop. Bend tag end of wire down 90 degrees and reposition tool as shown.
5. To form barrel wraps on bottom of twists, hold loop with left hand and rotate E/Z Twist 3 to 6 full turns clockwise with right hand. Remove wire from tool by roranting hex end counter clockwise to the open position.
6. Bend tag end of wire to form a crank. With fingers, hold tight at barrel wrap. With crank facing away from you, rotate clockwise until wire breaks.
